Thread: I'm tired of this ish!

Where are these damn crank sensors? I got three in this kit from the dealer for 80$. I need to install these before the 24th. Im tired of the car shutting off on red lights and it bogging down while cruising. I heard that this "recall" causes rough idle also which is annoying as hell already.

OT: Can i use a rubber mallet on a bend in the wheel so i dont damage it?
Also where can i buy a cheap bumper reinforcement bar for the rear? and i think ill be needing the stayback's(the things that you bolt it on to) also. Some bitch hit me. lol

i thought that recall was the computer recall ? havent heard of crank sensor recall hmmm

yea they have to reflash the ecu also..but there is a cps recall but not on mine.

Matt, call me about the reinforcement.

I need #8 and 7 from the picture. there are 2 #8 so i need both of those
http://www.trademotion.com/partlocat...=7&catalogid=2

crank sensor is right on the right side u should be able to see it.

the recall is a crank sensor and the 2 cam sensors... also no matter what kind of mallet you use to take out a bend in a wheel, you will risk cracking the wheel.

get a honda and u never have dat problem

Originally Posted by b20vtecdotcom

get a honda and u never have dat problem

BAN!

Matt i'll check those parts for you.

rofl @ the b20 post :clap:

ok so i found the sensors..BUT the parts guy gave me the wrong sensors. The crank sensor is straight but the replacement is L shaped so that doesnt fit at all. even the cam sensor doesnt fit..i hope that fool replaces it for me.