Thread: B15 "Widebody" front fenders and bumper

word imagine that on a daily lol

my phone sucks are viewing everything

Originally Posted by 2k4spec

what were the offsets on these rims?
how much was the rear pulled?

i know youve said it but whats one more time...

The rear was rolled flat, but not pulled much if any. There's room to fit a fairly wide tire under there with the right offset wheel.

Mines rolled pretty flat and i got a 9in with a 235 and it rubs a lil

I plan on doing that on my daily :P front and rear

Originally Posted by 2k4spec

Mines rolled pretty flat and i got a 9in with a 235 and it rubs a lil

What offset wheel? I had a 245 v710 on a 17x9 and no rub in autox conditions.

Originally Posted by psushoe

What offset wheel? I had a 245 v710 on a 17x9 and no rub in autox conditions.

+25 all around

That would be the problem If you want more meat you need more offset. Then buy my fenders for the front and reduce traction issues!

problem is the sexy as hell grids only come in a 17x9 +25 or a +12

Originally Posted by psushoe

That would be the problem If you want more meat you need more offset. Then buy my fenders for the front and reduce traction issues!

2 problems, i have an 04 so your bumper wont work
my front isnt too big of an issue
and daily/driving on 275s on street would be REDIC lol

Originally Posted by pandaspec

problem is the sexy as hell grids only come in a 17x9 +25 or a +12

lol eople run the +12...
to get any rims wide enought you need to go 5lug for some good options rofl 4lug 10in rims (im sure 240s do it)

Bump! Would be nice to have more shed space this winter....

*dead thread revival*

how did you go about making these? (I'm assuming you made them haha)

iirc they are molded in fiberglass

Clay molding, hand laid fiberglass, bondo, and lots of time. I still have these, by the way. If you want the setup I'll give you a good deal. It would take you way less time to come up from NC and get them than it did for me to make them.

I can only imagine the hours put into those..they look great. unfortunately the bumper wouldn't fit and I feel like it'd look goofy with just partial flares..

You can always change the hood and headlights

Originally Posted by MisterNuts

C'mon Jon, post #6!

typical.

Hey, this has nothing to do with the fenders, but did you need to make any modifications to fit the rear wheels? 6.8" backspace is the most I've ever seen fit, especially with 245/45 tires, which is tallest I've seen. I'm going to have a similar set up, so just wondering if besides bending in the rear fender lips if you had to do anything special.

Grr... If only these were closer, I would take them off of your hands. I'm in the process of deciding the best way to make my own.