B15U.com - A Nissan Sentra Forum
Page 1 of 8 12345 ... LastLast
Results 1 to 20 of 158
  1. #1
    Member Ashwin
    Join Date
    Dec 2005
    Location
    NYC
    Posts
    11,586
    Rides
    2
    Drives
    '03 QR25DE-T
    Likes Received
    558

    Default Pedal Relearn, Throttle Body Relearn and Idle Relearn

    Pedal Relearn Procedure
    Accerlerator Pedal Released Postion Learning is and operation to learn the full released postions of the accerlerator pedal by monitoring the accelerator pedal sensor output signal. It must be performed each time harness connector of accelearator pedal postion sensor or ECM is disconnected.

    1. Make Sure the acceleartor Pedal is fully released
    2. Turn Ignition switch ON and wait at least 2 Seconds.
    3. Turn ignition switch OFF and wait at least 10 Seconds
    4. Turn Ignition switch ON and wait at least 2 seconds.
    5. Turn Ignition switch off and wait at least 10 seconds

    Throttle Valve Relearn
    Throttle Valve Closed Postion Learning is to learn the fully closed postion of the throttle valve by monitoring the throttle position sensor output signal. It must be performed each time harness of
    electric throttle control actuator or ECM is disconnect.

    1.Make sure accelerator pedal is fully released.
    2. Turn ignition ON
    3. Turn igntion switch OFF and wait at least 10 seconds. Make sure that the throttle valve moves during the 10 seconds by confrming the operating sound.
    (You can hear the TB sound when you have key on and shifter in first gear and step on the gas. So you know what you listening for.)


    Idle Air Volume Relearn Procedure
    The Following Condtions Must be met in order for procedure to Work.

    Battery Voltage :More than 12.9 volts at idle
    Engine Coolant Temp 158-203 degrees Farenhiet
    Electric Load Switch OFF i.e Air Condition, headlamps , rear defogger
    Steering Wheel: Neutral Postion (Straight Ahead)
    PNP Switch: OFF (Park Neutral Switch i.e. Clutch Switch...pretty sure)


    1. Perform ACCERLEARATOR PEDAL RELEASED POSTIONS LEARNING
    2. Perform THROTTLE VALVE CLOSED POSITION LEARNING
    3. Start engine and warm it up to operation temperature
    4. Turn igniton switch OFF and wait at least 10 seconds
    5. Confirm Gas Pedal if fully realeased, then turn igniton switch ON and wait 3 seconds
    6. Fully step on and release gas pedal 5 time within 5 seconds
    8. Wait 7 seconds and fully step on gas and stay on until MIL stops blinking and is steady.
    9. Fully release the Gas pedal within 3 seconds after the MIL has turned ON steady.
    10. Start engine imediatly and let idle. Wait 20 seconds.

  2. #2
    Member Ashwin
    Join Date
    Dec 2005
    Location
    NYC
    Posts
    11,586
    Rides
    2
    Drives
    '03 QR25DE-T
    Likes Received
    558

    Default Re: Pedal Relearn, Throttle Body Relearn and Idle Relearn

    Originally posted by: 02specv_wi





    Attached Images Attached Images    
    Last edited by thesammythecurse; 04-16-2013 at 10:57 AM.

  3. #3
    Newbie Marcus
    Join Date
    Oct 2009
    Location
    Kansas City Mo
    Posts
    7
    Drives
    06 Spec V, 95 Eclipse GSX, 02 F150 Sport
    Likes Received
    0

    Default Trying it again

    This has been happening to me for about a month. I thought it was due to me having a minor accident. I tried to do the relearn as per the video, but no dice.
    I'm going to try again today, b/c it sucks being stuck at a light w/people honking at you to go. Thanks for you post Ash!

  4. #4
    Senior Member
    Join Date
    Sep 2009
    Location
    Queens,NY
    Posts
    2,394
    Rides
    1
    Drives
    02 Nissan SE-R SPEC V!!!!
    Likes Received
    190

    Default

    Does the throttle
    valve sound like a click?

  5. #5
    Newbie Marcus
    Join Date
    Oct 2009
    Location
    Kansas City Mo
    Posts
    7
    Drives
    06 Spec V, 95 Eclipse GSX, 02 F150 Sport
    Likes Received
    0

    Default

    Quote Originally Posted by frozenbarb View Post
    Does the throttle
    valve sound like a click?
    When turning off the engine you should hear a click. When it was acting up, I was hearing nothing.
    I ended up replacing the throttle body (partsgeek.com has it for under $200) and performing a relearn. I haven't had anymore issues since then.
    -Luke 9-

  6. #6

    Default

    i am having a semi related problem with my 2003 sentra spec v. a few days ago i would push the gas and nothing happens. a day later with the car still just idling, still nothing. so i towed it back to my house to work on it. started it the next morning and all it would do is turn over stutter and die, if i held the key down for a little bit longer i could force the car to start. and it would idle at about 600 rpms. today i bought a new pedal thinking it was the pedal not communicating. not the case as it would still do the same thing. so i called nissan and asked if they had a throttle body in stock and they did for 211 not a bad price. so i installed the throttle body and did all the relearn stuff and it starts just fine but surges from 1500 to 2500 and i dont know what to do anymore, i really dont want to take it to a shop. so any help you guys can give would be greatly appreciated.

  7. #7
    Newbie Alex
    Join Date
    Jul 2010
    Location
    Los Angeles
    Posts
    213
    Drives
    nissan sentra SE-R spec V
    Likes Received
    1

    Default

    I had the code p0507 but I didn't do nothing about it and today in the morning when I turned on my car the SES light didnt turn on ..
    Is this normal ?? Could the SES light just happen to go away??
    Last edited by saint677; 11-19-2010 at 10:44 PM. Reason: Incomplete

  8. #8

    Default

    nothing? come on guys help me out

  9. #9
    BDSF Karl
    Join Date
    Feb 2010
    Location
    Oakland, CA
    Posts
    10,968
    Rides
    2
    Drives
    Volvo V70 T5
    Likes Received
    1545

    Default

    Quote Originally Posted by lil_town_spec_v View Post
    nothing? come on guys help me out
    Did you follow the procedures listed above? You can always take it to the dealer to have them do the relearn.
    "Do you want to go fast or do you want to suck?" - Mike K.

  10. #10

    Default

    im pretty sure i did it all correctly but just to make sure im going to have a friend of mine come over in the morning to take a look at it he's been in a shop for about 20 years if he cant help me im gonna trailer it to nissan

  11. #11
    Newbie Aaron
    Join Date
    Aug 2010
    Posts
    44
    Likes Received
    0

    Default

    Quote Originally Posted by lil_town_spec_v View Post
    i am having a semi related problem with my 2003 sentra spec v. a few days ago i would push the gas and nothing happens. a day later with the car still just idling, still nothing. so i towed it back to my house to work on it. started it the next morning and all it would do is turn over stutter and die, if i held the key down for a little bit longer i could force the car to start. and it would idle at about 600 rpms. today i bought a new pedal thinking it was the pedal not communicating. not the case as it would still do the same thing. so i called nissan and asked if they had a throttle body in stock and they did for 211 not a bad price. so i installed the throttle body and did all the relearn stuff and it starts just fine but surges from 1500 to 2500 and i dont know what to do anymore, i really dont want to take it to a shop. so any help you guys can give would be greatly appreciated.
    This is what happened to me last month and I was retarded and brought it to the dealer...

  12. #12
    Newbie
    Join Date
    Aug 2010
    Location
    Hackensack NJ
    Posts
    158
    Drives
    02 Spec V
    Likes Received
    2

    Default

    make sure u guys r actually puttin the ignition off not on lock.. i wuss making that mistake and kept fuckin up.. then im like ... wow im a fucking idiot lol...

  13. #13

    Default

    Quote Originally Posted by Angelshield View Post
    This is what happened to me last month and I was retarded and brought it to the dealer...
    why were you retarded by taking it to the dealer beside the obvious high prices?

  14. #14
    Senior Member Doug E. Fresh
    Join Date
    Apr 2010
    Location
    M'boro TN
    Posts
    2,017
    Rides
    1
    Drives
    03 Spec V
    Likes Received
    90

    Default

    Quote Originally Posted by ash View Post

    1. Make Sure the acceleartor Pedal is fully released
    2. Turn Ignition switch ON and wait at least 2 Seconds.
    3. Turn ignition switch OFF and wait at least 10 Seconds
    4. Turn Ignition switch ON and wait at least 2 seconds.
    5. Turn Ignition switch off and wait at least 10 seconds

    The video says to do this 3 times not 2?

  15. #15
    Senior Member Doug E. Fresh
    Join Date
    Apr 2010
    Location
    M'boro TN
    Posts
    2,017
    Rides
    1
    Drives
    03 Spec V
    Likes Received
    90

    Default

    I was able to do this using the video but as soon as I turned the car on idle dropped and threw a 300 code and I still have a bad surge, will replace cam sensor tomorrow, and maybe crank if not fix problem. Any other thoughts?

  16. #16
    Newbie Troy
    Join Date
    Aug 2009
    Location
    Willoughby, Ohio
    Posts
    348
    Rides
    1
    Drives
    2005 nissan sentra se-r spec v
    Likes Received
    3

    Default

    Quote Originally Posted by SilverBullet View Post
    The video says to do this 3 times not 2?
    So is it 3 times or 2 times I'm confused? Ha
    RCBW!!!

  17. #17

  18. #18
    Newbie rich-bitch
    Join Date
    Dec 2010
    Location
    "G6u7A1m"
    Posts
    49
    Drives
    06' Spec-V
    Likes Received
    0

    Default

    i am pulling that PO507 code and i did the idle relearn like 5 times, shit is not working for my car???? any ideas!? im about to just get a new throttle body.

  19. #19
    Senior Member Adam
    Join Date
    Feb 2010
    Location
    ATL OTP North
    Posts
    2,929
    Rides
    2
    Drives
    03 spec
    Likes Received
    95

    Default


    Bolt-ons and BC 8's
    ALL people fall short of God's expectations. Message me for info, prayer request welcomed!
    Ephesians 2:9 NLT: Salvation is not a reward for the good things we have done, so none of us can boast about it.

  20. #20
    Senior Member Adam
    Join Date
    Feb 2010
    Location
    ATL OTP North
    Posts
    2,929
    Rides
    2
    Drives
    03 spec
    Likes Received
    95

    Default

    What a pain this was. Good feeling when you finally get it. The dork in movie said the engine was a 2.4 lol, then it shows a big ass 2.5 logo. The video was very helpful along with a stopwatch.

    Bolt-ons and BC 8's
    ALL people fall short of God's expectations. Message me for info, prayer request welcomed!
    Ephesians 2:9 NLT: Salvation is not a reward for the good things we have done, so none of us can boast about it.

 

 
Page 1 of 8 12345 ... LastLast

Similar Threads

  1. WTB: TPS/Throttle Body or borrow one
    By str8rpn in forum B15 Sentra (2000 - 2006)
    Replies: 5
    Last Post: 06-25-2009, 09:25 PM
  2. Throttle body
    By DPAKiNG in forum Parts for Sale
    Replies: 4
    Last Post: 05-16-2006, 07:17 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •